Schwarzbeck Mess - Elektronik

Switch to: deutsche Version
Homepage    Contact    international representatives    Application Notes    Used Equipment    Search
AntennasAntenna Masts / Tripods / AdaptersCDN 0.15 - 230 MHz, IEC 1000-4-6, EN 61000-4-6
EMI-ReceiversHelmholtz Coils / Radiating LoopsAbsorbing clamps / braid current blocking Clamps
LISN Line Impedance Stabilisation Networks and voltage probesNear field probesPulse Generators
Striplines / TEM-CellsAccessoriesDummy Lamps according to CISPR 15 EN55015
new Products
TypHelmholtz Coils / Radiating Loops
MagTest SystemSystem to test the immunity against magnetic fields acc. MIL-461 E, ISO 11452-8, EN 61000-4-8, SAE J551-17 etc. The system components will be individually configured for your requirements.
SHUNT 9570Low inductive precision high power shunt 0.25 and 1 Ohm 2 kW or 0.5 Ohm 1 kW respectively for best load matching at lower frequency end, cooling fans.
HHS 5201-6Helmholtz Coils circular up to 2860 A/m 5 MHz for DuT size 45 mm.
HHS 5201-98Helmholtz Coils circular up to 64 kA/m 200 kHz for DuT size 45 mm.
[Picture]
HHS 5203-20Helmholtz Coils, circular, diam. 300 mm, 330 A/m for Calibration or Immunity
[Picture]
HHS 5204Helmholtz Coils for Calibration purposes, circular, diam. 420 mm, 5 turns f. 60 A/m
HHS 5204-12Helmholtz Coils, circular, diam. 400 mm, 2500 A/m 500 kHz MIL-STD 461E, files for the MagTest software
[Picture]
HHS 5204-36Helmholtz Coils, circular, diam. 400 mm, 2500 A/m 150 kHz MIL-STD 461E
[Picture]
HHS 5206-16Circular pair of Helmholtz coils, diameter 600 mm, up to 2100 A/m, max. current 55 A.
HHS 5210Helmholtz Coils up to 300 A/m constant H field, 1 m x 1 m, 10 turns per coil, EN 61000-4-8, VDE 0847 part 4-8
HHS 5210-100Helmholtz Coils up to 2183 A/m constant H field, 1 m x 1 m, 100 turns per coil, EN 61000-4-8, VDE 0847 part 4-8
HHS 5212Helmholtz Coils up to 250 A/m H field, 1.20m x 1.20 m, 10 turns.
HHS 5213Helmholtz Coils 1.25 m x 1.25 m, 50 turns per coil, acc. EN 55103-2 A.2.1.b)
HHS 5213-100Helmholtz Coils 1.29 m x 1.29 m, 100 turns per coil.
HHS 5215Helmholtz Coils up to 200 A/m constant H field, 1,5 m x 1,5 m, 10 turns per coil
HHS 5215-100Helmholtz Coils up to 2000 A/m constant H field, 1,5 m x 1,5 m, 100 turns per coil
HHS 5218Helmholtz Coils up to 126 A/m constant H field, 1,8 m x 1,8 m, 10 turns per coil
[Picture]
HHS 5230-100Pair of Helmholtz coils according to SAE J551-17: 2 square coils with a side length of 3 m, 100 turns, max. 650 A/m, each coil movable separately on a wheeled platform. [Assembly]
NFCN 9731-100Matching network for HHS 5230-100 for the following frequencies: 16,666 Hz; 50 Hz; 60 Hz; 150 Hz; 180 Hz. Recommended amplifiers: 2 units of AE Techron 7224.
AGEM 5520Air gap electromagnet for extreme high magnetic field strengths of up to 2.2 Tesla.
FESP 5132Radiating loop diam. 12 cm, 20 turns, 15 Hz to 150 kHz, max 15 A, 2x Banana jack 4mm, ISO 11452-8, MIL-STD 461E RS101, EN 55103 5.18.3.2
Opt. LoopHolder50Calibration fixture to hold FESP 5134-40 in FESP 5132 in a distance of 50 mm acc. MIL461E figure RS101-3.
FESP 5134-40Loop Sensor / Antenna, diam 4 cm, 51 turns, 0 Hz to 150 kHz, electrostatic shielding, BNC jack.
FESP 5133-7/41Circular shielded loop sensor to determine the magnetic field strength. 36 turns AWG 7/41, diameter 133 mm, distance gauge 7 cm included. MIL 461E RE101 or RS101 alternative test procedures.
[Picture]
FESP 5133Loop Sensor / Antenna, 36 turns in 4 layers, diam. 133 mm, EN 55103-1 A.2.b), EN 55103-2 A.4.1 0 - 200 kHz, banana plugs (standard) or BNC connector female.
[Picture]
FESP 5133 1330Circular radiating loop for extremely high field strength up to several mT, 225 turns, acc. SF 01 G, VG95377.
FESP 5135Radiating coil diam. 0.5 m, 20 turns in one layer, acc. EN 55103-2 A.3.1
RSAL 5340LF 3-dimensional magnetic rolling stock antenna for the lower frequency range acc. to CLC/TS 50238-3:2010. 10 kHz to 100 kHz.
RSAH 53243-dimensional magnetic rolling stock antenna for the higher frequency range acc. to CLC/TS 50238-3:2010. 100 kHz to 1.3 MHz.
RSA COVERDirt and weather protection cover to house the rolling stock antennas RSAL 5340 or RSAH 5324 and to fix the antenna to the rail track.